Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Centennial?
Spring replacement in Centennial typically costs $180 – $340 for one torsion or extension spring, and most doors use a matched pair that’s replaced together, so plan on roughly $360 – $680 for the pair in most cases. The written estimate sets the final price, and we give that estimate free before any work starts. Springs are the highest-stakes repair on any garage door, so it’s worth getting a real number from a specialist rather than guessing.
When a spring lets go, the door usually stops mid-travel or won’t lift at all. If that’s where you are right now, call (877) 542-4141. We offer same-day service and fast dispatch from 7am to 7pm, and our technicians have up to 9 years of experience with torsion and extension spring work. One call covers it, whether you need spring replacement or a broader repair.
Key Takeaways
- One spring: typically $180 – $340. A matched pair: about twice that.
- Torsion and extension springs are both in scope. We handle the repair most general contractors won’t touch.
- Centennial’s dry, high-altitude air and big seasonal temperature swings put real wear on springs over time.
- Free estimates, upfront pricing, and a written quote that holds.
- Call (877) 542-4141 to book, including when the door fails early morning or on a Sunday.
Spring Replacement Cost Breakdown (2026)
Here’s how spring work breaks down for the Centennial market. These are typical estimated ranges, not exact quotes. A matched pair runs about twice a single-spring range because both springs are replaced at once:
| Job | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Matched pair of springs | About $360 – $680 |
| Cable repair (often done alongside springs) | $130 – $250 |
| Roller replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| General garage door repair | $150 – $600 |
| New door installation | $700 – $2200 |
What pushes a spring job toward the top of the range? A heavier door. If you have a double-car door with a thick insulated panel, the springs are wound to a higher tension and cost more to spec and install than a single-car setup. Spring material and cycle rating matter too. A standard-cycle spring and a high-cycle spring carry the same size footprint but different life spans, so the quoted price reflects which one your door needs. Worn cables or corroded drums found during the job can add $130 – $250 or so, and that’s work we do in the same visit rather than booking a second trip.
We work on every major brand: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That matters on spring jobs because the right spring spec depends on the door’s make and weight, not a generic guess. If you’ve got a Clopay or Amarr door that’s been sticking, a technician familiar with how those doors are built will size the spring correctly the first time.
What Affects Spring Replacement Pricing in Centennial
No two doors are identical, and several factors move the price up or down. Here’s what we look at:
- Door weight and size. A single-car door with a light shell takes a lighter spring than a double-door with an insulated panel. The heavier the door, the higher the tension spec, and the more the spring costs to supply and wind.
- Torsion versus extension springs. Torsion springs mount across a shaft above the door and carry more tension and more setup care. Extension springs run along the sides and are a different job. Both are in scope, but torsion work is more involved.
- Centennial’s climate. Our high-altitude, dry air and the wide swing between warm afternoons and cold nights work springs hard. Steel contracts and expands season to season, and metal fatigue tends to show up faster than in mild coastal climates. If your door has been creaking more through a cold snap, that’s often a sign the springs are near the end of their cycle life.
- Cycle rating of the spring. A standard spring and a high-cycle spring look similar but last different amounts of time. If you plan to stay in your Centennial home for years, a higher-cycle spring costs a bit more up front but spreads the cost across far more open-and-close cycles.
- Condition of related parts. Cables, drums, and rollers take the same daily load as the springs. If a cable is fraying or a drum is worn, fixing it during the spring job saves a second visit and prevents a repeat breakdown.
- Access and door height. A tall door or one tucked into a tight garage bay takes longer to set up safely, which can nudge the labor side of the estimate.
Because Centennial homes sit at elevation, some doors here run slightly heavier hardware than you’d find at lower altitudes, and that’s something our technicians account for when they spec a spring. It’s also why we ask about your door’s brand and age when you call, so the estimate we give is close to the final number.
Safety First: Why Springs Are the Highest-Stakes Repair
Springs store an enormous amount of energy. A torsion spring under load can cause serious injury if it’s handled without the right tools and training, and the same goes for the cables and drums working alongside it. We don’t hand out step-by-step instructions for replacing a spring yourself, because this is genuinely one of the most dangerous jobs in home repair. If a spring is broken, leave the door down, don’t try to force it open, and let a trained professional handle it. That’s not a sales line. It’s how the trade works, and it’s why spring replacement is a named service here rather than something we wave off to a general handyman.
If you’re not sure whether your spring is the problem, we can diagnose it. A door that’s hard to lift, bangs when it moves, or won’t stay up when you let go usually points to a spring or cable. Call us and we’ll tell you what’s going on and what it costs to fix.
How to Save on Spring Replacement
You can’t skip the spring spec, but you can avoid paying twice for the same problem. A few practical ways to keep the number down:
- Replace the pair, not just the broken one. When one spring fails, the other is usually the same age and hours away from going. Doing both together costs about twice the single-spring range but saves you a whole second service call and the labor that goes with it.
- Fix cables and rollers in the same visit. Bundling small repairs into one appointment means one trip charge and one block of labor, rather than three separate calls over a season.
- Get the estimate in writing before work starts. Free estimates and upfront pricing mean you know the number before anyone touches the door. No surprise add-ons after the fact.
- Don’t ignore the warning signs. A creak or a door that’s getting harder to lift is cheaper to address now than after a spring snaps and takes a cable or drum with it. Catch it early and the job stays at the lower end of the range.
- Ask which cycle rating fits your use. If you open and close the door several times a day, a higher-cycle spring can be the better value over time.
We give free estimates, and we’ll tell you honestly whether you need one spring or two, and whether anything else on the door needs attention. Call (877) 542-4141 to set up a time. We handle work early in the morning or on Sunday too, so a spring that goes overnight doesn’t leave you stuck all week.
Spring Repair vs. New Door: Which Makes Sense?
In most cases, a broken spring means a spring repair, not a new door. The door itself is fine; it’s the tension hardware that’s worn out. If your panels are straight, the tracks are true, and the opener is working, replacing the springs is the far cheaper path. General garage door repair in Centennial runs $150 – $600, and a full new door installation runs $700 – $2200. A spring job sits at the low end of the repair scale, so there’s rarely a reason to replace a sound door just because the springs failed.
The exception is a door that’s already damaged: bent panels, a rusted-through bottom section, or tracks that won’t stay aligned. If a panel is cracked, panel replacement runs $250 – $500, and if several sections are gone it may be more sensible to put that money toward a replacement. We’ll tell you which way the math points. Same door, fixed right, is our default. If your door is a name brand, like a LiftMaster-equipped Clopay or an Amarr, keeping the original door and repairing the springs usually costs less than starting over, and you keep a system your opener already knows.
Can You Come Today?
Often, yes. Spring replacement is one of our core services, not a side job we squeeze in, and we offer same-day service with fast dispatch from 7am to 7pm. A door that won’t open in the morning or won’t close at night is exactly the kind of call we’re set up for. When you reach out, tell us your door’s brand and what it’s doing, and we’ll get a technician out to diagnose the problem and give you an upfront price. If it turns out to be a cable or a track rather than the springs, we handle that too, so you’re not bounced to a different trade.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Centennial?
Spring replacement in Centennial typically costs $180 – $340 for one spring, and most matched pairs run about twice that, roughly $360 – $680, because both springs are replaced together. The written estimate sets the final price. Call (877) 542-4141 for an exact quote; estimates are free.
Do I need to replace both springs at once?
Yes, in most cases. A matched pair has lived through the same cycles and hours, so when one breaks the other is usually close behind. Replacing the pair costs about twice the single-spring range but avoids a second service call later. Call (877) 542-4141 and we’ll confirm whether your door uses a pair or a single spring.
Is it cheaper to repair the spring or replace the whole door?
Repairing the spring is far cheaper. A spring job runs $180 – $340 per spring, while a new door installation runs $700 – $2200. You only move toward replacement if the panels or tracks are genuinely damaged. Call (877) 542-4141 for a free estimate and we’ll tell you which makes sense for your door.
Why do springs fail faster in Centennial?
Our dry, high-altitude air and big swings between warm days and cold nights put steady stress on spring metal, and that shortens its cycle life compared with milder climates. The result is more frequent spring failure over time. When yours goes, call (877) 542-4141 for a same-day visit.
What should I do when a spring breaks?
Leave the door down, don’t force it open or closed, and call a trained technician, because a loaded spring can cause serious injury. Don’t attempt the repair yourself. Call (877) 542-4141 and we’ll dispatch a technician with spring tools and the right replacement parts.
Can you fix a broken spring on a name-brand door?
Yes. We’re factory-familiar with LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so we diagnose by brand-specific logic and spec the correct spring for your door. Call (877) 542-4141 and mention your brand when you book.
Work With a Dedicated Spring Specialist
Here’s the practical difference with us: garage-door-only specialization means every technician’s skill is concentrated on one trade. We’re not a multi-trade contractor doing doors on the side, and we’re not a general handyman guessing at a spring spec. Our technicians have up to 9 years of experience with torsion and extension springs, and we work on the eight major brands homeowners in Centennial actually own. When it won’t open and you can’t wait, one call covers it.
Pricing is upfront, estimates are free, and we stand behind the work with a satisfaction guarantee. For a wider look at what we handle, visit Centennial Garage Door Repair Pros or call us directly to book your spring replacement today. We’ll give you a real number, fix the door right, and get your garage back to normal.
Ready to get that spring fixed? Call (877) 542-4141 for a free estimate and fast dispatch from 7am to 7pm.
Pricing reflects the Centennial market as of 2026. Centennial Garage Door Repair Pros offers free estimates – call (877) 542-4141.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Heather Hayes"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
- Rafael Delgado"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Todd Ziegler